BaseCam 3-axis BGC controller by Mongrel Gear
OUR BOARDS ARE NOW FULLY LICENSED BY BASECAM
This Gimbal Controller supports 3-Axis brushless gimbals
The board runs the now famous SimpleBGC software for easy config!
This board is very easy to configure and setup. Firmware is already loaded, so you only need to make minor adjustments.
You can also hook it up to your Flight Controller to stabilise, and you can hook it into your Rx to control it from your radio. :)
It will run our Harrier Brushless Gimbal and any other for that matter. :)
NOTE - This board is NOT made by SimpleBGC.
- Dimension: 50mmx50mm
- Weight: 25g(include IMU board)
- Brushless Gimbal Controller x 1
- IMU board x1
- 3rd Axis Daughter Board
- Cables etc
Find the GUI HERE-->